Description

🔧 CleverSpa Water Pressure Flow Switch – Fix No Heat Issue

✅ Restore Heating to Your CleverSpa Hot Tub

If your CleverSpa has no heat, the water pressure flow switch is one of the most common causes.

This small but essential component detects water flow and allows power to reach the heater element. If it fails, your heater will not activate — leaving you with a cold tub.

❌ Common “No Heat” Symptoms

If your CleverSpa is not heating, you may notice:

• No heat at all despite pump running
• Heater not activating
• Pump runs but water stays cold
• Intermittent heating issues
• No error codes but still no heat

👉 In many cases, this is caused by a faulty or worn pressure switch

🔍 What Does the Pressure Switch Do?

The water pressure switch confirms there is sufficient water Pressure before allowing the heater to turn on.

If the switch:

• Fails
• Gets stuck
• Or cannot detect flow properly

👉 The system will block the heater for safety, resulting in a no heat condition

🔧 The Fix

Replacing the CleverSpa water pressure flow switch restores correct detection of water flow and allows the heater to operate again.

💡 It is also recommended to replace this switch when fitting a new heater element, as both work together.

💪 Built for Reliability

• ✔ Direct replacement for CleverSpa models
• ✔ Durable, long-lasting design
• ✔ Restores proper heating function
• ✔ Compatible with AquaSpirit models (where applicable)

🔧 Easy DIY Installation

• Minimal tools required
• Straightforward replacement
• Step-by-step guidance available

Get your CleverSpa heating again quickly without the need for expensive repairs.

⚠️ Important Note

If your heater still does not work after replacing the pressure switch, check:

• Heater element
• Main Circuit Board
• Connections for corrosion

📦 What You’ll Receive

• CleverSpa Water Pressure Flow Switch

Please contact us here for more information.